BMS protection card for 6 to 13S batteries, max current 25A
Battery management system for LI-ION battery
Protection and charge management of lithium-ion cells
Requires a 6S, 7S, 8S, 9S, 10S, 11S, 12S, 13S LITHIUM ION charger
Sold individually
For mounting battery Pack BMS PCB PCM
Specification:
The polymer is wired the same way as lithium iron phosphate, using the same output port.
Step 1: Line B to lithium battery negative
Step 2: Connect the cable (make sure the cable is unplugged from the protection board, start the wiring from B-,
8-connect the full negative pole of the battery, the second line B1 of the cable is connected to the first string of the battery
positive of the lithium battery) The third line B2 is connected to the positive pole of the second series of batteries of the lithium battery, followed by
Step 3: insert the cable after checking if there is no error.
Dimensions: 55 x 26.3 x 4mm
Main duties:
overload protection, short circuit protection, over current protection.
Precautions:
Before installing the protection board, you must be sure that the battery is well matched, the voltage difference between each battery should not be 0.05V
the smaller the voltage difference, the better the protection board will work.
If it is the replacement of an old electronic card, please pay attention to the proper functioning of the batteries.
During installation, use a multimeter to check the battery voltage.