Lifepo4 BMS 2S 6.4V 10A Battery Protection Board Charging PCM PCB
HS-2S-D01
Dimensions: 41 x 16 x 3.5mm
Use current: 8A
Max peak current: 10A
End of charge voltage per cell: 3.65v +- 0.05v
Discharge voltage in protection: 2v +-0.05v
standby current: 30µA
Charging voltage: 7.2v -8.4v
Short circuit protection
Sold individually
For mounting battery Pack BMS PCB PCM
Main duties:
overload protection, short circuit protection, over current protection.
Precautions:
Before installing the protection board, you must be sure that the battery is well matched, the voltage difference between each battery should not be 0.05V
the smaller the voltage difference, the better the protection board will work.
If it is the replacement of an old electronic card, please pay attention to the proper functioning of the batteries.
During installation, use a multimeter to check the battery voltage.